VLAN 100 on wan port for GL-B3000 Marble

[mbooma]

Hi,

My GL-B3000 have 4.5.19 firmware.

To setup the router with my ISP ONT, I have to spoof the mac adress and chager the vendor class when requesting IP ( i already did this), but I have also to pot WAN port to VLAN 100.

I tried this How to configure WAN VLAN on MV1000 Brume? - #3 by l3db3tt3r

now I have :

but it doesn't seeem detected the ONT, I have always this message (with or wthout cable)

Error: Network device is not present

I alredy did configuration for the same ISP with another OPENWRT router and it was much easier...

any help please ?

thank you

[mbooma]

Hi,

I figure out how to do it, I added interface eth1.100 to wan, than I go to the normal GUI and on ethetnet 1 on DHCP SETUP a put VLAN 100.

I don't really understand but it work, why we have Ethernet 1 and ethernet 2 on the GUI? I thought that's for LAN configuration but it seem refer to WAN PORT (at lest for ethernet 1)

also I enebled IPV6 on GUI, than go to ludi and configred wan 6 to ger IPV
adress

now I have to figure out how to configure igmp proxy to make TV working.

thank you