Wifi client without repeater on Baryl AX

Technical Support for Routers
1

Is it posible to use Baryl AX as wifi client (bridge to LAN ports) only, without retransmiting its own wifi network? I can make it as such in repeater mode, then disable wifi, but it stay connected only for a while or until the first restart. Then it dont connect to upstream wifi anymore without enabling wifi again.

2

I tested in MT3000 with v4.7.0 firmware, and disable all WiFi, and the repeater connected normal and re-connect normal when the router rebooted.
Cannot reproduce.

  1. please share the syslog
  2. SSH:
cat /etc/config/wireless
cat /etc/config/repeater

Checked twice, after repeated and after rebooting (cannot repeat).

4

I tried on 4.6.9 and then on beta 4.7.0. Upstream wifi is Flint2.
log.txt.zip (1.6 KB)

5

The configuration of the wireless and repeater seem does not issue.

But the syslog did not share with me, please PM me the syslog, export from GL GUI -> System -> Log.

Since I did not reproduce this issue in my router with v4.7.x, if possible please reset the MT3000 and try it one more time in the v4.7.0