Flint 3 VPN and LAN routing by SSID

[reln]

Hey all,

I recently got the Flint 3 and would like to set up my network with some selective VPN and LAN routing by SSID.

SSID "Fast" does not use a VPN [MLO 2.4+5+6 GHz]

SSID "Main" forwards all internet traffic through a VPN, and can also access devices on "Fast" over LAN (and maybe vice-versa) [5+6 GHz]

SSID "IoT" uses the VPN but cannot access data on any LAN, and is also blocked from accessing the 192.168.3.x subnet over the VPN [2.4 GHz]

SSID "Guest" does not use the VPN, and cannot access LAN (normal Guest SSID works here) [2.4+5+6 GHz]

Looking for any recommendations on how I could configure this on the Flint 3.

I saw a few relevant posts for the Flint 2 for reference:

Multiple Networks (and SSID's) with Selective VPN Routing on MT6000

Please SSH to the router and execute these, it will add the SSID radio group of 'GL Router-Custom' and 'GL Router-IoT': # /etc/config/network uci add network device # =cfg1b0f15 uci set network.@device[-1].type='bridge' uci set network.@device[-1].name='br-iot' uci set network.iot=interface uci set network.iot.proto='static' uci set network.iot.device='br-iot' uci set network.iot.ipaddr='192.168.11.1' uci set network.iot.netmask='255.255.255.0' # /etc/config/dhcp uci set dhcp.iot=dhcp uci s…

Thanks!

[bruce]

Hi,

This custom configuration is not supported in the v4.7.x firmware.

@reln

SSID "IoT" uses the VPN but cannot access data on any LAN, and is also blocked from accessing the 192.168.3.x subnet over the VPN [2.4 GHz]

Let's wait for the Flint 3 v4.8.0 firmware release.