Hello @ardiross ,
Are you copy and pasting the commands by any chance? You have to manually type them in… The commands are run at 2
First I changed these settings manually in the admin page of the router:
TTYUSB3
LTE/UMTS/GPRS
VSBLINTERNET (I typed this where you chose the apn on MUDI)
then
AT+QPRTPARA=3
AT+QMBNCFG=“AutoSel”,0
AT+QMBNCFG=“Deactivate”
AT+CFUN=1,1
After running AT+CFUN=1,1 the modem will reset so return to the router homepage and wait then enter the following commands:
AT+CGDCONT=1,“IPV6”,“VSBLINTERNET”
AT+QCFG=“usbnet”,2
AT+QCFG=“nwscanmode”,3,1
Then reboot Router.
I recently had to downgrade my router back to 3.100 because after I updated to 3.105 it began to act erratically and would drop both cellular and wifi connections. After the downgrade, my router would not connect even after I ran the above commands. So I ran these commands again:
AT+QMBNCFG=“AutoSel”,0
AT+QMBNCFG=“Deactivate”
AT+CFUN=1,1
and eventually after a few tries and letting it sit for a few minutes at time connected!
