GL-MT3000 stops working when connecting to Tailscale Exit Node

[Gravity8602]

I had a similar issue and was able to solve it in a few different ways:

Beryl AX (GL-MT3000) using a tailscale exit node

Luci configuration safe. Thank you that is good to know. You can install the TS client in the phone/computer, etc, to verify whether the exit node is available. This works fine, I have been using this exist node with my phone and laptop for a while. If available, please reset router and enable the TS in the GL admin panel, rebind it (let the TS re-create the route table), and in general there are not require configuring anything in the LuCI and SSH. Just to clarify the ssh config I di…