GL-X3000 is a Wi-Fi 6 cellular gateway Advanced configuration

Hello I would like to configure the router in the following way if it is possible.

  1. The cellular network and 1 ethernet port on Vlan3
  2. The WIFI will be bridged with existing Lan and the other internet port on VLAN1

cellular network on vlan3 will act as a gateway in PFsense and the wifi and vlan 1 will act as an access point. tor traffic on vlan 1

I tried setting up vlans under the bridge but each time it reset the config and did not accept changes.

If it is a permanent configuration, you can try making the settings to uci commands and put them in /etc/rc.local.
After each restart, it will be automatically set to achieve the permanent configuration.

Cool do you have an example on how to achieve the above? Thx.

VLAN settings depends on your customize configuration.
After Luci is configured, click Save (not click Save and Apply). There is an operation record in the upper right corner, and the commands of UCI are included.

After doing one operation, optimize them as you need and put them in rc.local.