Lost mesh and Luci after 3.211 firmware update (GL-B1300)

[limbot]

I recently did a new mesh with 3.211 beta 6 on an S1300 (master) with 2 B1300 slaves.

Don’t know if this assists:

B1300 Mesh setup

Ok, when I first got a couple of B1300s I had a lot of problems getting the mesh setup. I recently ended up getting a third node for a bit more coverage and maybe took a bit more time to set it up. In the end, I think all the initial issues I had with the mesh was basically just being too impatient. Instead of waiting for things to setup I’d go “it’s not working” and reset everything. The third node connected first time. Keep in mind too this post here Here’s my Amazon review that’s waiting…